Chameleon sump kit water features

Three Kits to suit most sizes of water features.

Complete with Sump, Heavy metal grid, plastic mesh, Hose tail and clip
Select your matching base kit.
Every component you need to install your stone (excl. pump).

KIT 1
Recommended for stone up to 50cm tall
KIT 2
Recommended for stone up to 80cm tall
KIT 3
Recommended for stone up to 110cm tall

Installing Sumps Kits

Installing your water feature Installation only takes a few hours using the simple step by step instructions here.

Turn reservoir upside down and mark out circumference with spade.

Add 2.5cm (1”) layer of sand in bottom of hole to make a level base.

Place grid on reservoir. Cover with two layers of fine mesh to prevent debris falling in. Cut hole in centre of mesh and pull tubing through.

When the reservoir is full, switch pump on and adjust water flow until you are satisfied with the effect. Finally cover mesh with stones, arrange the plants, stand back - and enjoy.